NEVER leave this heater unattended. ALWAYS unplug this heater when not in use.
ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.
NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or connections.
Plugging this heater into a faulty outlet could result in electric arcing within the outlet that could cause
the outlet to overheat or catch fire.
ALWAYS check your heater cord and plug connections with each use!
I)MAKE SURE the plug fits tig ht in the outlet! Faulty wall outlet connections or loose plugs can cause
the outlet to overheat.
II)Heaters draw more current than small appliances. Overheating may occur even if it has not
occurred with the use of other appliances.
III)During use check frequently to see if the plug outlet or face plate is HOT!
IV) If the outlet or face plate is HOT, discontinue use immediately and have a qualified electrician
inspect and/or replace the faulty outlets.
The power cord supplied with the heater has three prongs:
two flat blades (live and neutral) and one round pin (ground).
If a 3-slot receptacle is not available, an adapter MUST be
used. The adapter MUST be properly grounded to the outlet
box (see figure at rig ht).
[NOTE: Adapter NOT INCLUDED.]
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for wall-hanging or recessing use. Check the parts list to make sure
nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Philli ps screwdriver; stud finder; level; tape measure;
electric drill; 1/4” wood drill bit, hammer.
WARNING
Preparing for Installation
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.
3
Grouding Pin
Adapter
Metal Grounding
Screw
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord
connection, and wire the appliance directly to the house hold wiring.
SAVE THESE INSTRUCTIONS!