STARTING AND USE INSTRUCTIONS
TERMINATOR-1000
Rev. 000
20/12/04
23/35
4.7.6 SQUEEGEE ADJUSTEMENT
The squeegee has to be well regulated in order to have a perfect dry system. This kind of squeegee can
perfectly suck water, which flows into the suction pipe, but it must be parallel to the surface.
¾
Remove the ignition key from the dashboard in order to avoid the casual starting of the machine.
¾
By means of the knob (see detail nr. 2 in picture nr. 4.10) regulate the squeegee. The best squeegee
pressure is reached when the corner of its blade is in contact with the floor and their inclination is
between 45° and 60°.
¾
Squeegee pressure regulation: the operator has to work on the squeegee driving wheels cam pins .
The operator has to unloose the screw at the bottom of the pin by means of the spanner delivered
with the machine. Afterwards the operator has to tighten this screw again (see detail 1 in picture
4.10).
Make sure that the two wheels of the squeegee are well regulated in order to keeps both its
blades parallel to the floor.
4.7.7 WATER DISCHARGE
This scrubber machine is equipped with two pipes for water discharge (picture 4.15.):
¾
A pipe for the solution tank discharge (see detail nr. 1 in picture nr. 4.15.);
¾
A pipe for the recovery tank discharge (see detail nr. 2 in picture nr. 4.15.);
¾
Suction pipe (see detail nr. 3 in picture nr. 4.15.);
¾
Recovery tank cap (see detail nr. 4 in picture nr. 4.15.).
If you need to discharge water from the tanks, you have to place the machine on a dump well, release the
pipe of the tank and open the rubber cap at the end of the pipe itself.
PICTURE N° 4.15
2
2
1
PICTURE N° 4.10
3
1
4
