FINO 86000, User Information

Page: 7 / 10

5.3 Working with an LED ring light
LED episcopic illumination (ring light) is supplied for
illumination of the specimen to be examined under
the microscope.
Use:
• Unscrew the three plastic screws (11) out of the
LED episcopic illumination (ring light) (10) only
until these screws no longer extend into the
opening for the objective tube (4).
• Push the LED episcopic illumination (ring light)
(10) over the objective tube (4) as shown in the
illustration under 2. Device setup, and carefully
tighten the three plastic screws (11).
• Plug the mains adapter supplied into a properly
connected socket and connect the connector of
the adapter cable with the socket (12) on the
LED episcopic illumination (ring light).
• Set the on/off switch for LED episcopic
illumination (ring light) (13) to position "I".
• Set the required illumination using the
MAX-MIN control (14).
• After use, set the on/off switch (13) to the "0"
position and switch off the LED episcopic
illumination (ring light).
6. Service and maintenance
• Do not use aggressive chemical substances,
solvents or scouring agents to clean the surface.
• After use, cover the device with the dust-
protection hood supplied in order to keep
dust and dirt to a minimum.
• Remove dirt using a soft, slightly moistened
cloth.
• Use a lens cleaning cloth to clean the oculars (1).
Be very careful when cleaning the oculars as their
surfaces can scratch easily.
7. Storage
Cover the device with the dust-protection hood
supplied.
Store unit in a dry and dust-free place.
8. Technical data
8.1 With stand, item no. 86000
Metal stand, column length 18.0 cm; Flat base 20.0 x
15.0 cm; Widefield oculars (pair) WF 10x; Revolver 1x
and 2x for magnification 10x/20x; LED episcopic illu-
mination (ring light) 100-240 V, 50/60 Hz; 3.6 W;
Power cable 2 m.
8.2 With joint arm, item no. 86001
Metal joint arm 85.0 cm; Widefield oculars (pair) 10x;
Magnification 10x/20x; LED episcopic illumination
(ring light) 100-240 V, 50/60 Hz; 3.6 W; Power cable
2 m.
9.Delivery forms
9.1 With stand, 1 unit, item no. 86000
FINO stereo microscope complete with stand; LED
episcopic illumination (ring light); Widefield oculars
(pair) 10x; Ocular viewfinders; Dust protection hood
and power cable.
9.2 With joint arm, 1 unit,
item no. 86001
FINO stereo microscope complete with spring-joint
arm; Table clamp; Screw-on-flange; Four screws;
Socket wrench; LED episcopic illumination (ring
light); Widefield oculars (pair) 10x; Ocular viewfin-
ders; Dust protection hood and power cable.
Accessories
FINO LED episcopic illumination
(ring light)
1 pc. 86011
FINO widefield oculars (pair) WF 5x 1 pc. 86002
FINO add-on lens 0.5x 1 pc. 86006
10. Guarantee
Our technical recommendations of application are
based on our own experiences and tests and should
only be regarded as guidelines. It rests with the skills
and experience of the user to verify that the products
supplied by us are suitable for the intended proce-
dures. Our products are undergoing a continuous
further development. We reserve the right of
changes in construction and composition. It is
understood that we guarantee the impeccable quali-
ty of our products.
7
ENU