23
DISPLAY MODE SETTING
Two display formats are available:
“Single” display and “Dual” display
formats. To access the display
format setting, enter the Main Menu.
Navigate to the “Display Setup”
menu entry using “ ” softkey. When
highlighted, enter the Display Setup
menu by selecting the “
” softkey.
Navigate through the “Display Setup”
menu using “ ” softkey until the
“Display Mode” entry is highlighted.
Choose the desired display mode setting by cycling through the list of choices using the
Change “ ” softkey.
DEFAULT DISPLAY
To configure a particular display as the default startup display, access the desired display and
leave active for 5 minutes. The system will automatically set this display as the default startup
display.
ENGINEERING UNITS
Displayed engineering units
can be configured for Pressure,
Temperature and Volume. To
access the engineering unit’s
settings, enter the Main Menu.
Navigate to the “Display Setup”
menu entry using “ ” softkey.
When highlighted enter the
Display Setup menu by selecting
the “
” softkey. Navigate through
the “Display Setup” menu using
“ ” softkey until the desired
engineering unit’s parameter is
highlighted.
Choose the desired parameter
setting by cycling through the list
of choices using the change soft
key.
Summary of Contents for HydroSeeder T170 MB
