18
CONTENTS
4 •
MANAGING USER
Administrator and Administrator Card
Enrollment of an Administrator Card is required before any other operations could
take place in a terminal. Once an Administrator Card is available, an administrator
can perform these 3 major functions.
1. Unlock a terminal for enrollment or/and deletion of users with fingerprints or
cards
2. Download data from a terminal with a USB flash disk
3. Reset the terminal to its default factory settings
An administrator card cannot be used to report attendance or gain access; it is solely
used for the above operations. To gain access or to report attendance, an adminis-
trator must enroll his/her fingerprint into a terminal.
“The terminal is providing users with vocal instructions”. Follow the instructions
carefully.
Registration of Administrator Card
Power up terminal > Red LED blinks >
“Please register the administrator card”
> Wave card at the card induction area > Terminal reads card and beeps once >
“Registration is successfu” > System returns to verification mode > The Green
LED blinks > Terminal is in stand by mode.
Remark:
If the green LED blinks when you power on the terminal, it means that the terminal has already
been enrolled with an Administrator card. Find the administrator card to proceed or you need to reset
the terminal in order to enroll with a new administrator card.
Enrolling Cards Users
Green LED blinks > Wave administrator card at the card induction area >
“Register
user”. Please press your finger or wave your card > Wave card at the card induction
area > Terminal reads card and creates a new user ID >
e.g: “User number 2”
“Registration is successful”. Register, Please press your finger
(
Remark:
Ignore this voice
instruction if you do not intend to register a fingerprint in the terminal)
> Wave administrator card
an to induction area to end process >
“System returns to verification mode”.
Remarks:
1. Repeat steps above to enroll new card users. The system will automatically assign a user ID starting
from number 2. By default, User ID 1 is for an administrator card.
2. If you would like to enroll fingerprint for the user after card registration, continue with the steps below
after you hear
“
Registration is successful”. Register, please press your finger
“
Registration is successful”. Register, please press your finger > Press finger on scanner for first
capture >
“
Please press your finger again” > Lift the finger and press again on scanner for second
capture >
“
Please press your finger for the last time” > Lift the finger and press again on scanner for
third capture >
“
Registration is successful”. Register, please press your finger > Repeat enrollment
