http:// en.fineart-light.com
- 39 -
Picture 18
6. When reinstalling the module, verify that the guide pins are
correctly seated and that the module is securely locked.
The dismount of the strobe modules
1. See Picture 19: Like the gobo module, the strobe module is also
can be released by pulling the levers on each side towards the center,
and then lift the strobe module straight up to remove from the head.
Picture 19
2.
When reinstalling the strobe module, verify that the guide pins are
correctly seated and that the module is securely locked.
Note
: The gobo module must be removed before the strobe module.
http:// en.fineart-light.com
- 40 -
Cleaning
Regular cleaning can prolong the service life and ensure the good
performance of the fixture. Use care when cleaning optical components. The
coated surfaces are fragile and easily scratched. Do not use solvents that can
damage plastic or painted surfaces.
Cleaning of optical components
1
、
Disconnect the fixture from power and allow the components to cool
completely, and then remove the cover.
2
、
Vacuum or gently blow away dust and loose particles with compressed
air.
3
、
Remove stuck particles with an unscented tissue or cotton swab
moistened with glass cleaner or distilled water. Do not rub the surface
and blow away loose particles with compressed air
4
、
Remove smoke and other residues with cotton swabs or unscented
tissues moistened with isopropyl alcohol. A commercial glass cleaner
may be used, but residues must be removed with distilled water. Clean
with a slow circular motion from center to edge and dry with a soft
cotton cloth.
Cleaning of fan and air vent
Remove dust from the head fans and air vents with a soft brush, cotton
paper, vacuum, or compressed air.
Cleaning and replacement of the air filter
1
、
See picture 20: Disconnect the fixture from the power supply. On each
side of the fixture, remove the 2 screws that hold the side covers with
cross screwdriver; slide the covers forward to remove, and then remove
the air filter.
2
、
Get rid of the dust in the air filter with cleaner or pressed air. If they are
saturated with smoke fluid, etcetera, soak them in warm soapy water
and blot dry
3
、
Position the filters on the side covers and reinstall it.
