Installation steps (caution: the following installation should under no power, otherwise will be dangerous)
5.3 Startup
5.3.1
Installed the tracker in the car,then put the SIM card into the tracker host outdoors.
5.3.2
For first use, please initialize the unit and restore it to default setting.( please refer to 5.4 for instruction.)
5.3.3
In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well as the GPS signals,
and the red indicator will keep flashing every 2 seconds when the GPS module is in standby mode. When the
blue indicator is keep shine, the unit has been located.
5.3.4
When this unit receives GPS signals normally, you can use it and do all the following settings.
5.4 Initialization
Send
�
begin+password
�
in SMS to the unit, it will reply
�
begin ok
�
and initialize all the settings. (Default
password: 123456)
5.5 Change the password
5.5.1
Send SMS
"pold p space +new password
to change the password.
Wire for cutting off oil of the tracker
Yellow wire connects the relay feet 86; 85
feet to 12 V DC anode, 87 feet and 30 feet in
series in the supply oil circuits.
Wire for cutting off circuit of the tracker
White wire connects relay feet 86; 85 feet
to 12 V DC anode, 87 feet and 30 feet are in
series in the supply power circuits.
Emergency triggering alarm
The blue wire connects the anode of the
alarm button, and the black wire connects the
cathode of the alarm button.
Power supply line
The red wire connects 12V
+
�
;Black wire
connects to12V
-
�
