Fimer Tp 72, Instruction Manual

Page: 9 / 20

910.100.276GB REV00 9 di 28
PRESSURE REGULATOR:
Keep pressure regulators in good condition. Damaged regulators they cause damage or serious accidents, they must
be repaired only by qualified personnel
Do not use regulators for gases other than those for which they were manufactured.
Never use a damaged regulator.
Never lubricate a regulator with oil or grease.
Hose:
Gas hose used for plasma cutting systems adheres to the following colour coding:
Green or Blue: Oxygen
Black: Inert gas or air
NEVER USE OXYGEN FOR PLASMA CUTTING.
Immediately replace the hoses that are damaged by cuts or burns.
Do not bend the hoses to avoid bottlenecks that reduce the pressure.
Periodically examine the hose for any leaks, wear or faulty connections.
OVERVIEW
THE PACKAGE CONTAINS:
No. 1 Generator TP. No. 1 Instruction booklet.
No. 1 Heart cable. N°1 Torch.
INTRODUCTION
The TP cutting generators are designed for cutting all metals: aluminium, stainless steel, iron, etc..
The TP generator is composed of:
A) Current generator.
B) Cutting torch
C) ground cable with clamp
The essential parts of the TP generators are:
−
Electronic control card.
−
Power Electronic control card.
The use of inverter systems allows for a compact generator, to cut on restricted areas, and achieve high quality.
The high frequency used by the inverter (35 kHz) allows you to control the arc in the most suitable for the
cutting. Changes in the input line voltage or in the load do not produce change in the cutting current. Particular
design attention was paid to design a cutting machine that guarantees good performance, longevity and low
maintenance; to achieve this FIMER adopted solid-state electronics, both for the power electronic, both for the
control. It is well known for the absolute reliability of these components, after the first operating period, during which
any construction defects could cause breakage (the "infant mortality").
FIMER use highly selected oversized
components and performs a test bench for every unit built.
FIMER has prepared this manual to provide the user with both instructions for use, is the description of the principles
of operation for the TP plasma cutting generators.