24
EXTRAORDINARY MAINTENANCE
33. REPLACING THE FRONT SQUEEGEE RUBBER
Suction will be poor and the machine will not dry perfectly if the front squeegee rubber is worn. Proceed
as follows to replace:
1.
Deactivate the main switch by turning it to “OFF”
2.
Remove the squeegee from its support arm by unscrewing the handwheel
3.
Turn the wing nuts (1) to the horizontal position
4.
Remove the front rubber-pressing blades (2)
5.
Remove the rubber (3) and replace it
6.
Proceed in reverse to replace the rubber
WARNING: before carrying out any type of maintenance, put the main switch
on “OFF” and disconnect the machine battery connector (battery-operated
version) or disconnect the power supply cable from the mains socket (electric
version).
WARNING: These operations must be carried out using gloves to protect
against contact with dangerous solutions
34. REPLACING THE REAR SQUEEGEE RUBBER
If the squeegee rear rubber is worn and does not dry well, it is possible to change the drying edge using
one of the 4 edges of the rubber.
This operation can be done both with a squeegee fitted or removed as follows:
1.
Deactivate the main switch by turning it to “OFF”
2.
Turn the wing nuts (1) to the horizontal position
3.
Remove the rear rubber-pressing blades (2).
4.
Remove the rubber (3) and replace it
5.
adjust the height of the squeegee depending on the rubber (see “ADJUSTING THE HEIGHT OF
THE SQUEEGEE SUPPORT”)
WARNING: before carrying out any type of maintenance, put the main switch
on “OFF” and disconnect the machine battery connector (battery-operated
version) or disconnect the power supply cable from the mains socket (electric
version).
WARNING: These operations must be carried out using gloves to protect
against contact with dangerous solutions
3
2
1
1
2
3