Fimap GMG PRO, Operator Interface Manual

Page: 39 / 68

RESET DELAY MENU (BRUSHES SWEEP MOT)
Proceed as follows to change the “RESET DELAY” parameter in the brush motor menu:
1. Display the "MACHINE BRUSHES SETTINGS" menu - see “SETTINGS MENU” on page 9 .
2. Display the “SERVICE” menu - see “SERVICE MENU” on page 16 .
3. Display the “PARAMETERS” menu - see “PARAMETERS MENU (SERVICE)” on page 17 .
4. Display the “BRUSHES SETS” menu - see “BRUSHES SETS MENU (PARAMETERS)” on page 34 .
5. Display the “SWEEP BRUSH” menu - see “SWEEP BRUSH MENU (GENERAL SETS)” on page 38 .
6. Using buttons (1) and (2) ( Fig.1 ) select the "RESET DELAY" screen ( Fig.2 ).
7. As soon as the “RESET DELAY” screen ( Fig.2 ) is displayed, select the delay in seconds before the actuator
brings the brush head to the "raised from the floor" position using buttons (3) and (4) ( Fig.1 ).
N.B.: the selected value will be visible in the text string (5) in the lower part of the screen ( Fig.2 ).
8. Confirm the selection by pressing the button (6) ( Fig.1 ).
Brushes
Sweep Mot
20 [s]
Reset delay:
min:1 max:300
2
5
2 4
1 3
6
1
N.B.:
The “RESET DELAY” parameter indicates the standby time before the actuator moves the sweeping
brush head into the “lifted off the floor” position.
N.B.:
The “RESET DELAY” parameter is expressed in seconds (s), the numerical value is between a
minimum of 001 and a maximum of 300, the selectable increment is one unit.
N.B.: The “RESET DELAY” parameter is set in the factory to 20.
2
1
1
Sweep Mot
2
Brushes
Page 39