11
PREPARATION OF MACHINE
8. RECHARGING THE BATTERIES
Perform a battery charging cycle before using the machine.
When replacing the battery, be sure to use batteries that are suitable for the battery charger installed (use only 12V
AGM or Gel batteries).
To charge the battery you must:
1.
Make sure the recovery tank and the solution tank are empty
2.
Move the machine near to the battery charger
3.
Remove the battery charger connector socket protection on the back of the machine (1)
4.
Plug the battery charger cable (supplied with the machine) into the freed socket
5.
Plug the battery charger cable into the mains socket
6.
For the correct use of the battery charger, follow the instructions in the enclosed booklet.
ATTENTION: If one of the three LEDs flashes refer to the battery charger manual
supplied with the machine
ATTENTION: The machine is equipped with an automatic system that disconnects the
power supply from the electrical system while the batteries are being recharged
ATTENTION: In order not to cause permanent damage to the batteries, it is essential to
avoid their complete discharge: arrange the recharge within a few minutes of the
switching on of the "discharged batteries" blinking light.
ATTENTION: Never leave the batteries completely flat, even if the machine is not being
used.
ATTENTION: For the daily recharging of the batteries, you must fully respect the
indications provided by the manufacturer or retailer. all installation and maintenance
operations must be carried out by specialised personnel.
ATTENTION: Do not move the machine when the battery charger power supply cable is
connected to the battery charger.
ATTENTION: Danger of gas exhalation and leakage of corrosive liquids.
ATTENTION: Danger of fire: Keep naked flames at a safe distance.
In the event that the charger is not built-in with the machine, carefully read the manual of the charger that is used to
recharge.
