Fimap FS50 B-BT, Use And Maintenance Manual

Page: 9 / 24

9
MACHINE PREPARATION
5. BATTERY FITTING (FS50 B-BT VERSION)
The machine can be supplied with batteries included.
If using a battery other than those supplied with the machine, check that the size is suitable for the
battery compartment
Perform a battery charging cycle before using the machine.
The batteries must be housed in the appropriate compartment beneath the recovery tank, and must
satisfy the requisites of Standard CEI 21-5.
To insert the batteries you must:
1. Make sure the main switch is in the “0” position
2. Rotate the hood of the machine until it stops
3. Lift the battery by means of the grips on the upper part
4. Place the battery into the compartment
WARNING: you are advised to use airtight batteries only, to avoid the leakage
of acids!
ATTENTION: you are advised to always wear protective gloves, to avoid the
risk of serious injury to your hands
ATTENTION: You are advised to only lift and move the batteries with lifting
and transportation means suitable for the specific weight and size
6. CONNECTION OF THE ELECTRICAL POWER SUPPLY CONNECTOR (FS50 B-BT VERSION)
Beneath the recovery tank there is the battery connector (2), in which the electrical system connector (1)
must be inserted.
7. BATTERY RECHARGING(FS50 B-BT VERSION)
In order not to cause permanent damage to the batteries it is essential to avoid their complete discharge:
arrange the recharge within a few minutes of the switching on of the flashing "discharged batteries"
signal.
ATTENTION: never leave the batteries completely discharged, even if the
machine is not being used. Check the battery charger is suitable for the
batteries installed, in terms of both capacity and type.
1
2