Fimap FS50 B-BT, Use And Maintenance Manual

Page: 12 / 24

12
WORK
1. PREPARING TO WORK (FS50 B-BT VERSION)
1. Check that the main switch of the machine is set to "0"
2. Open the hood of the machine
3. Connect the battery connector (2) to the electric system connector (1)
4. Lower the hood
5. Make sure the debris hopper is positioned and latched properly
6. Turn the main switch of the machine in position "1"
ATTENTION: before using the machine, the operators must be suitable trained.
We therefore suggest you read this instruction booklet carefully and read it again
whenever difficulties arise while using the machine
2. PREPARING TO WORK(FS50 H-HT VERSION)
WARNING: Before starting the engine, carefully carry out the checks listed in
the user manual of the Honda GX100 engine supplied with the machine
WARNING: In terms of optimizing the use of the machine, an engine speed
has already been selected
ATTENTION: before using the machine, the operators must be suitable
trained. We therefore suggest you read this instruction booklet carefully and
read it again whenever difficulties arise while using the machine
3. WORK
The operator operates the machine from the ground standing behind the machine and holding the
handlebar
The forward drive for the FS50 B and FS50 H versions is given by the operator, while for the FS50 BT
and FS50 HT versions the drive is activated by pressing the lever on the handlebar.
Once the machine is running the main brush will begin to turn, from this moment on you are ready to
work.
ATTENTION: if the machine is used in places where there is a risk of falling
objects, the operator must be provided with all the appropriate protection devices
as laid out in the legal requirements
In the presence of bulky waste, to allow access to the main brush that picks them up, the machine must
be raised more by pressing on the handlebars.
1
2