Fimap 109070, Service Manual

Page: 18 / 104

The batteries don’t work properly
1. The batteries are not properly connected
⇒
Connect the loop wire and the output cables cor-
rectly.
2. The batteries are discharged
⇒
Perform a complete charge cycle.
3. Battery terminal are oxidized
⇒
Disconnect the batteries, clean the batteries ter-
minals and reconnect properly the batteries, pro-
tecting the connections with grease.
4. With the machine in working conditions one
battery has a voltage lower (difference higher
than 2 V) than the other ones
⇒
Replace the battery with lower voltage.
5. The fuse on the loop wire is damaged
⇒
Check for possible short circuits, If not present
replace the loop wire.
6. The power wires are damaged
⇒
Replace the damaged wires.
7. The battery charger is not properly adjusted ⇒ Adjust the battery charger properly
(see section
3.5.2 at page 39 )
.
8. The battery charger doesn’t work
⇒
Check the proper section
(see section 2.1 at page 18 )
.
The battery charger doesn’t work
1. The battery charger is not connected to the
power supply ⇒ Connect the charger to a supplied electric socket.
2. The battery charger is not connected to the bat-
teries
⇒
Connect the charger to the batteries.
3. The battery charger is not properly adjusted
⇒
Adjust the battery charger properly
(see section
3.5.2 at page 39 )
.
4. The battery charger has one or more lights (or
LEDs) blinking continuously
⇒
The battery charger is in error conditions, verify
the alarm tables and solve the issue by following
the related instructions
(see section 3.5.2 at page 39 )
.
5. The battery charger is properly connected but
it doesn’t switch on
⇒
Replace the battery charger.
18