Fimap 109070, Service Manual

Page: 17 / 104

Chapter 2
Trouble-shooting
2.1 Electrical system: what to do if. . .
The machine doesn’t switch on
1. The emergency button is pressed
⇒
Release the emergency button.
2. The key is in position 0
⇒
Rotate the key in position I.
3. The key switch is not properly connected
⇒
Restore the proper connections.
4. The key switch doesn’t work
⇒
Replace the key switch
(see section 3.3 at page 27 )
.
5. The batteries don’t work properly
⇒
Check the proper section
(see section 2.1 at page 17 )
.
6. The machine is powered properly
⇒
Check the battery charge level and if necessary
perform a recharge cycle or replace it.
The machine has a very limited working autonomy
1. The BDI (Battery Discharge Indicator) is not
properly adjusted
⇒
Verify the type of battery used on the machine
and adjust properly the BDI
(see section 3.6.1 at
page 41 )
.
2. The batteries have been working for several cy-
cles ⇒ Replace the batteries.
The display shows an alarm message
1. The display shows an alarm message
⇒
Check what alarm message is shown and solve
the related issue by following the proper instruc-
tions
(see section 3.4.1 at page 34 )
.
17