Fimap 109070, Service Manual

Page: 39 / 104

3.5.2 Battery Charger (CB)
The battery charger is mounted on the recovery tank behind the operator seat. At the start of the charging
cycle, the charger indicates the selected charging algorithm by the LED flashing.
A Proper Charging cycle follows the below phases order.
Charging cycle
Phase LED Description
A Green Flashes, confirms Charge Curve Setting
B Red First charging phase
C Yellow Second charging phase
D Green Charged battery
Check if the charger is properly set according to the installed batteries.
Charger Set up
To set up the charger, follow the instructions:
ˆ
Remove the charger from the machine.
ˆ
Set-up the internal dipswitches according to the following table
The dipswitches are divided in two couples.
The higher couple are the dipswitches 1 and 2, the low
couple are the dipswitches 3 and 4.
The dipswitches 1, 2 4 are enabled
The dipswitch 3 is disabled.
The following table shows how to setup the dip-
switches.
Set-up of Charging Curve
DP1 DP2 DP4 Set Up Yellow LED Green LED Flashes
OFF OFF OFF IUI0-Pb Flooded OFF 1
ON ON OFF IUoU-Gel Trojan OFF 2
OFF ON OFF IUoU-AGM GEL OFF 3
ON OFF OFF IUI0-Gel Sonnenschein OFF 4
OFF OFF ON IUIa-Pb Flooded ON 1
ON ON ON IUI0-AGM EV-Discover ON 2
OFF ON ON IUa-AGM Zenith ON 3
ON OFF ON IUIa-Gel Sonnenschein ON 4
39