(Fig. 12)
(Fig. 13)
(Fig. 14)
HOT
COLD
(Fig. 6)
(Fig. 8)
(Fig. 9)
2
1
/
2
"
(Fig. 10)
(Fig. 11)
(Fig. 7)
ATTACH WATER
INLET/OUTLET HOSES:
You will need: 1 length of 1/4
"
tubing (D).
1. Insert one end of the length of 1/4
"
tubing (D) into
the push-in fitting on the side of the water supply
line adapter (E) you just installed. Push the tubing
in firmly as far as it will go to ensure a watertight fit.
(Fig. 12)
Important Note: Water may leak if the tube
is not pushed in completely. (See “push-in fittings”
explanation on Pg. 3. Fig. 1)
2. Take the other end of the same 1/4
"
tubing (D)
and insert into the left (inlet) side of the filter
head assembly (B). (Fig. 13)
3. Insert the end of the faucet tubing into the right (outlet)
side of the filter head assembly (B). (Fig. 14)
5
ATTACH WATER SUPPLY
LINE ADAPTER:
You will need: Adjustable wrench (Note: Two
wrenches may be needed to adequately tighten
fittings when connecting the adapter to the
supply line), water supply line adapter (E)
1. Turn off the cold water supply at the shutoff
valve under the sink. (Fig. 9)
2. Place bowl under cold water connection.
Disconnect the cold water faucet hose from
the shutoff valve below using wrenches.
Leave the hose attached to the faucet
above. (Fig. 10)
3. Install water supply line adapter on water supply
shut-off valve. (Fig. 11)
4. Reconnect the cold water faucet hose onto threaded
portion of water supply line adapter. (Fig. 11)
Note: If the water supply line adapter (E)
does NOT fit properly onto the end of your
shutoff valve, visit your local hardware store
to purchase the correct size.
hand should be on
left side
hand and tube
should be on right
side
