HOT
COLD
(Fig. 6)
(Fig. 8)
(Fig. 9)
2
1
/
2
"
(Fig. 10)
(Fig. 11)
(Fig. 7)
4
MOUNTING THE FILTER
HEAD ASSEMBLY:
You will need: Phillips screwdriver, drill, pencil,
safety glasses, filter, head assembly (B),
#2 mounting screws (I)
1. Choose a location to mount filter head assembly
(B). Keep in mind: Filter head should be in
a location that offers easy access for changing
filters. Leave 2 ½" of clearance below the installed
filter cartridge. (See Fig. 6)
2. Using the bracket on the head (B) as a guide,
mark the location of the two screw holes on the
wall with a pencil. (Fig. 7)
3. Fasten the head to the wall using a Phillips
screwdriver and the two mounting screws
included (L) (Fig. 8). (If preferred, use a drill
with a 1/8" size drill bit to make pilot holes
for the screws.)
4. Check to assure mounting bracket is
firmly installed.
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)
INSTALL FAUCET:
You will need: faucet with attached tubing, nut (C), faucet mounting shim (F), faucet gasket (G),faucet spout (H).
1. Place the faucet gasket (G) on the faucet and insert faucet tubing, shaft and nut (C) into pre-existing soap dispenser or sprayer
opening in sink. (If no opening exists, or installation is desired elsewhere, a 1 ¼" opening must be made.) (Fig. 2)
2. Install faucet mounting shim (F), onto faucet shaft (Fig. 3) and hand tighten nut. (Fig. 4)
3. Insert spout (H) into faucet body (C). Hand tighten faucet spout nut. (Fig. 5)
Faucet Opening
Insert Shim
Tighten Nut
Spout Insert
