PM 1 Installation and Operating Manual v1.2
36
FilterSense © 2016
11 Spare Parts
Spare parts for the PM 1 include the following:
PM 1 Electronics Module
PM 1 Enclosure and Sensor/Nipple/Probe Assembly
section for spare parts configuration and examples. Add SP to a part
number to specify a spare part.
11.1 Electronics Module Replacement
The PM 1 is designed so that the electronics module can
be easily replaced. An electronics module can be
replaced by following the steps below:
1.
Remove the cover to the PM 1.
2.
Record all settings from the existing electronics
module.
3.
Disconnect all power to the PM 1.
4.
Remove all wiring (power and outputs) from the
terminal connections.
5.
Remove the entire device from the process.
6.
Remove the two 9/64" hex screws that connect
the electronics module to the enclosure.
7.
Remove the electronics module from the
enclosure and replace with spare electronics
module.
8.
Follow the above steps in reverse to complete
the replacement.
Summary of Contents for DynaCHARGE PM 1 PRO-A
Page 2: ......
