Filtec Omnivision 1000 Series, Upgrade Installation Manual

Page: 60 / 70

52 Omnivision Upgrade Installation Manual
Document 45277-0805
Testing CB4 Circuit.
1. Remove connector if OSW option is included PL1-J5 (TO OSW
DC POWER).
2. Turn CB4 ON.
3. Verify that the voltage at PL1-J5 is 120VAC.
4. Turn CB4 OFF and reconnect the connector PL-P5.
Testing CB5 Circuit.
1. Disconnect MTR3-P1 (Diffuser Drive Motor)
2. Turn CB5 ON
3. Verify that the voltage at MTR3-P1 is 120VAC
4. Turn CB5 OFF.
Testing CB6 Circuit.
1. Turn CB6 ON.
2. Verify that the voltage at PL1-J1 and Fan3-P1 is 120VAC.
3. Turn CB6 OFF.
Testing CB7 Circuit.
1. Disconnect XFMR4-P1 (Base Strobe Transformer)
2. Turn CB7 ON.
3. Verify that the voltage at XFMR4-P1 is 120VAC.
4. Turn CB7 OFF.
Testing CB8 Circuit.
1. Remove the following connector:
• XFMR3-P1 (Finish Strobe XFMR)
2. Turn CB8 ON.