Setup
1.
Power up the panel.
2.
The panel will automatically see the expansion card when it powers up and the additional zones 5 to 8 will
be active (switched on). If there are no devices connected to new zones 5 to 8 then four EOL faults will be
generated.
3.
It will be necessary to switch off any unused zones to prevent EOL faults. For example if only six zones are
going to be used the two un-used zones will need to be switched off otherwise the panel will always be in
fault.
4.
Switching off un-used zones is done as follows:
(a) Log in to engineer level and selecting
“zones” (option 6) in the main menu.
(b) Set the write enable switch to on.
(c) While still within the zones menu, select
“zone status” (option 1)
(d) You will then have to enter the zone number to be switched off and then press enter.
(e) You will now be able to toggle the on/off status of the selected zone.
Repeat steps (c) to (e) above for the next zone.
(f) Remember to set the write enable switch back to off when finished.
Technical Data
For specifications of the TwinflexPro² Panel when upgraded to 8 Zones, please see the TwinflexPro² Engineering &
Commissioning Manual.
Technical Support
Contact your supplier for technical support on this product.
Due to the complexity and inherent importance of a life risk type system, training on this equipment is essential, and
commissioning should only be carried out by competent persons. Fike cannot guarantee the operation of any equipment unless all
documented instructions are complied with, without variation. This unit complies with the EMC directive.
Fike’s policy is one of continual improvement and the right to change a specification at any time without notice is reserved.
Whilst every care has been taken to ensure that the contents of this document are correct at time of publication, Fike shall be
under no liability whatsoever in respect of such contents. E&OE.
TWINFLEX, Fike and Fike Corporation are registered trademarks of Fike Corporation and its subsidiaries. All other
trademarks, trade names or company names referenced herein are the property of their respective owners.
26-1509 Issue 2
