Fieldmann FZS 70705-0, User Manual

Page: 17 / 116

EN
CORDLESS BRUSH CUTTER USER'S MANUAL
17
Operation
6. OPERATION
WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless
action of a second is suffi cient to infl ict serious injury.
WARNING: Always wear eye protection, along with hearing protection. Failure to do so could result in
objects being thrown into your eyes and other possible serious injuries.
WARNING: Do not use any attachments or accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not recommended can result in serious personal injury.
Applications
You may use the brush cutter for the purpose listed below:
With 3-teeth blade: Cutting grass, weeds, wild growth and scrub, thinning young stands with a maximum
stem diameter of 2cm.
With Trimmer Head: Trimming grass and weeds from around porches, fences and decks.
1. BEFORE OPERATION
NOTE:
a) Do not use any charger other than that specifi cally provided for use with the equipment.
b) If the battery pack is very hot you must remove your battery pack from the charger and allow time for the
battery to cool down before recharging.
c) The battery in your new tool is not charging when it leaves the plant. Therefore it must be full charged before
using the fi rst time.
d) Please charge the battery to reach full or no less than half charge before storage. If the tool will not be used for
long periods of time, charge the battery every 3-6 months.
Assemble the machine (See Fig G1)
Insert two batteries on the machine. You can use it following the “3 START/STOPING” step in next page.
Charging procedure (See Fig. G2)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the charger and
remove the battery pack.
WARNING: When battery charge runs out after continuous use or exposure to direct sunlight or heat, allow
time for the battery to cool down before re-charging to achieve the full charge.
Notice: The tool is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse.
CHARGING INDICATOR
Light Status
Red on
Charging
Green on
Fully Charged
This charger can fully charge 1 battery for 1 hr, 2 batteries for 2 hrs.
2. HOLDING THE MACHINE
Hold the tool with both hands on the right side of your body. The trimmer head or blade should be parallel to the
ground at a proper cutting distance without the operator bending over. (See. Fig. H)