EN
CORDLESS GARDEN SHEARS
USER’S MANUAL
15
Electrical safety
The accumulator charger can be connected to any power plug, preventing discharge, that is installed according
to standards in force.
The plug must be powered at 230 V 50 Hz.
Disconnect the charger if you will not be using it for a long time, if you are changing the tool or performing
maintenance on the tool.
10. MAINTENANCE AND STORAGE
Maintenance
ATTENTION!
Remove the battery from the tool if you are not using it. Remove the battery even if you replace
the blade.
Check whether the device is not showing signs of wear.
If the charger is damaged (cover, conductors or connector), immediately arrange their replacement at an
authorised service centre or from the vendor.
Regular care for the machine will ensure not only a long lifetime and performance.
Before use always visually check for worn or damaged parts.
Replace damaged or worn parts. To ensure that the tool always remains balanced, always replace the entire
set of the worn or damaged tools.
Worn or damaged machine parts may only be replaced at an authorised service centre or arranged by the
vendor.
Before cleaning disconnect this appliance from the power source.
To clean the plastic parts of the appliance, use a soft cloth dipped in lukewarm water.
Do not use aggressive cleaning products and solvents as this could damage the surface of the product.
Do not clean the machine under running water or submerge under water.
After changing the working tool, check that the working tool is secured in its correct position.
After every use of the shears, the blade must be cleaned and lubricated. If the shears are used non-stop for
extended periods of time, lubrication should be performed during work.
Storage
Store the tool in a dry location at a suffi cient distance from heat sources or dangerous vapours. Do not place any
other items on the power tool.
Operating instructions
|
Maintenance and storage
