Fieldmann FDUO 70505-0, User Manual

Page: 13 / 84

EN
CORDLESS RECIPROCATING SAW USER’S MANUAL
13
Assembly
8. ASSEMBLY
Battery and charger not included in the package.
Before any work on the machine itself (e. g. maintenance, tool change, etc.) as well as during transport and
storage, remove the battery from the power tool. There is danger of injury when unintentionally actuating the
On/Off switch.
Battery Charging
Use only the chargers listed in the technical data. Only these chargers are matched to the lithium-ion battery
of your power tool.
Note: The battery supplied is partially charged. To ensure full capacity of the battery, completely charge the
battery in the battery charger before using your power tool for the fi rst time.
The lithium-ion battery can be charged at any time without reducing its service life. Interrupting the charging
procedure does not damage the battery.
Removing the battery (see fi gure B)
To remove the battery 8 , press the battery unlocking button 11 and pull the battery out of the power tool
toward the rear.
Do not exert any force.
Replacing/Inserting the Saw Blade
When mounting the saw blade, wear protective gloves. Danger of injury when touching the saw blade.
When changing the saw blade, take care that the saw blade holder is free of material residue, e. g. wood or
metal shavings.
Selecting a Saw Blade
An overview of recommended saw blades can be found at the end of these instructions. Use only ½”
universal shank saw blades. The saw blade should not be longer than required for the intended cut.
The shank thickness of the sa w blade must be 0.8–1.6 mm. Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see fi gure A)
Press the SDS clamping lever 4 forward and guide the saw blade behind1 the clamping plate 10 into the
saw blade holder . Relea3se the SDS clamping lever 4. Check the tight seating by pulling on the saw blade.
A loose saw blade can fall out and cause injury. For certain work, the saw blade 1 can also be turned
through 180° (with the teeth pointed upwards) and re-inserted again.
Removing the Saw Blade
Before removing, allow the saw blade to cool down. Danger of injury when touching the hot saw blade.
Press the SDS clamping lever 4 forward and pull out the saw blade . Relea1se the SDS clamping lever 4.
Dust/Chip Extraction
Dusts from materials such as lead-containing coatings, some wood types, minerals and metal can be
harmful to one’s health. Touching or breathing-in the dusts can cause allergic reactions and/or lead to
respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with
wood-treatment additives (chromate, wood preservative). Materials containing asbestos may only be
worked by specialists.