Fieldmann FDUO 70505-0, User Manual

Page: 10 / 84

EN 10
FDUO 70505-0
General safety instructions | Specifi c safety instructions
Service
Do not change parts of the tool, do not perform repairs on your own and do not interfere with the
tool’s construction in any way. Leave tool repairs to qualifi ed persons.
Each repair or product modifi cation performed without our company’s permission is inadmissible (it can
cause injury or harm to the user).
Always leave tools to be repaired in a certifi ed service centre. Use only original or recommended spare parts.
This will ensure your and your tool’s safety.
4. SPECIFIC SAFETY INSTRUCTIONS
WARNING! Before use, please read these safety Instructions and store them with care.
Please ensure that the voltage of the mains power supply corresponds to the value stated on the type plate.
The tool is equipped with a two-pole lead and plug!
Wear safety glasses and a face or dust mask if the cutting or drilling operation is dusty. When using the tool
for extended periods, or where the noise level is high, use adequate hearing protection.
If devices are provided for the connection of dust extraction and collection facilities, ensure these are
connected and properly used. Always empty the dust collection bag when full.
Use clamps or a vice to hold the work piece. It is safer than using your hand and frees both hands to operate
the tool.
Ensure the power cord is arranged so that it cannot be tripped over, stepped on or have heavy weights rested
on it; and make sure that the cord will not be subjected to any damage.
A risk of injury exists in the case that instructions in this manual are not followed. The reciprocating saw
complies with valid technical regulations and norms.
When working with the reciprocating saw, the protective cover must always be pushed down.
Regularly check both screws on the clamp of the saw blade.
Do not use damaged or worn saw blades.
Regularly check the setting of the guide pulley.
Do not turn the saw on if the saw blade slid into the workpiece.
Never overload the saw so much that the engine ceases.
Never try to stop the movement of the saw blade, even when the engine is turned off.
The saw blade itself is removed very quickly. The blade’s teeth are very sharp.
Never aim the saw at another person.
Use protective gear against noise, dust and vibrations!!!
WARNING! Keep these safety instructions!!!