Fieldmann FDUK 70305 - 0, User Manual

Page: 20 / 24

EN 20
Adjustments
FDUK 70305 - 0
WARNING! If inner blade washer has been removed, replace it before placing blade on spindle. Failure to
do so could cause an accident since blade will not tighten properly.
Fit the saw blade inside the lower blade guard and onto the spindle. NOTE: The saw teeth point upward at the
front of the saw.
Replace the outer blade washer.
Depress the spindle lock button, then replace the blade screw. Tighten the blade screw securely by turning it
counterclockwise.
Return the blade wrench to the storage area.
NOTE: Never use a blade that is too thick to allow the outer blade washer to engage with the fl ats on the spindle.
REMOVING THE BLADE
See Figure 2, page 3.
Remove the battery pack from the saw.
Remove the blade wrench from the storage area.
Position the saw as shown, depress the spindle lock button, and remove the blade screw by turning it
clockwise.
Remove the outer blade washer.
Remove the blade.
9. ADJUSTMENTS
WARNING! To prevent accidental starting that could cause serious personal injury, always remove the
battery pack from the product when making adjustments.
0° BEVEL STOP
See Figure 20, page 6.
The saw has a 0° bevel stop that has been factory adjusted to assure 0° angle of the saw blade plate when
making 90° cuts.
CHECKING 0° BEVEL STOP
Remove battery pack.
Place the saw in an upside down position on a workbench.
Check the squareness of the saw blade plate to the base of the saw using a carpenter’s square.