FIC PA-2010+, Manual, Page: 64 / 76

Award BIOS Setup
Doze Mode
When disabled, the system will not enter Doze mode. The specified time
option defines the idle time the system takes before it enters Doze mode.
The options are: Disabled (Default), 10, 20, 30, 40 sec, 1, 2, 4, 6, 8, 10, 20,
30, 40 min, 1h.
Suspend Mode
When disabled, the system will not enter Suspend mode. The specified time
option defines the idle time the system takes before it enters Suspend mode.
The options are: Disabled (Default), 10, 20, 30, 40 sec, 1, 2, 4, 6, 8, 10, 20,
30, 40 min, 1h.
VGA I/O & MEMORY
Selecting ON will enable the power management timers when a no activity
events is detected in the VGA. Selecting OFF to disable the PM timer even if
a no activity event is detected. The options are: OFF (Default), ON.
LPT & COM I/O
Selecting LPT & COM will enable the power management timers when a no
activity event is detected in the LPT and COM ports. Selecting LPT (COM)
will enable the power management timers when a no activity event is
detected in the LPT (COM) ports. Selecting NONE to disable the PM timer
even if a no activity event is detected.
The options are: LPT & COM (Default), LPT, COM, NONE.
HDD & FDD I/O
Selecting ON will enable the power management timers when a no activity
event is detected in the hard disk drive and floppy disk drive. Selecting OFF
to disable the PM timer even if a no activity event is detected.
The options are: OFF, ON (Default).
IRQ# Activity
After the time period which you set at in Suspend Mode Feature, the system
advances from Doze Mode to Suspend Mode in which the CPU clock stops
and the screen display is off. At this moment, if the IRQ activity which is
defined as Primary occurs, the system goes back to Full-on Mode directly.
If the IRQ activity which is defined as Secondary takes place, the system
enters another low power state, Dream Mode, in which the system will act as
Full-on Mode except that the screen display remains off until the
corresponding IRQ handler finishes, then back to Suspend Mode.
49