FIC PA-2010+, Manual, Page: 17 / 76

Installation Procedures
RAM Module Configuration
SIMMs and DIMMs in Bank 0 and Bank 1 can be installed in many
combinations. Some of them are listed in the following table.
(Unit : MB)
TOTAL
MEMORY
SIMM 1 & 2
(Bank 0)
SIMM 3 & 4
(Bank 1)
DIM1
(Bank 0)
DIM2
(Bank 1)
8 4 & 4
8
16 8 & 8
16
32 16 & 16
32
64 32 & 32
64*
128 64 & 64
64* 64*
256 64 & 64 64 & 64
512 128* & 128* 128* & 128*
NOTE :
1. * A RAM module of this size was not available for testing at press time.
2. DIM1 and DIM2 only support 3.3V (unbuffered) EDO and SDRAM |||||
modules.
3. It is recommended that SIMMs and DIMMs are not installed at the same
time on this mainboard to avoid unexpected failure.
4. DIM2 and SIMM 1&2 are shared. That is, It is not allowed to install RAM
modules on DIM2 and SIMM 1 &2 at the same time.
5. This mainboard allows the SIMMs (without ECC or parity check support)
which latency time are 70ns, 60ns, 50ns; and for the DIMMs which
latency time are 10ns, 12ns.
15