FIC PA-2010+, Manual, Page: 13 / 76

Installation Procedures
1). Set System Jumpers
Jumpers
Jumpers are used to select the operation modes for your system. Some jumpers
on the board have three metal pins with each pin representing a different
function. To
set
a jumper, a black cap containing metal contacts is placed over
the jumper pin/s according to the required configuration. A jumper is said to be
shorted
when the black cap has been placed on one or two of its pins. The
types of jumpers used in this manual are shown below:
NOTE : Users are not encouraged to change the jumper settings not listed in
this manual. Changing the jumper settings improperly may adversely affect
system performance.
Clear Password: CPW
This jumper allows you to set the password configuration to Enabled or
Disabled. You may need to enable this jumper if you forget your password.
11