FIC CW001, User Manual

Page: 43 / 116

Getting Started
2
43
After the test, the screen will also display a message "press <F2> to enter
SETUP". You don’t need to run this program at the moment as your dealer
already made the necessary settings for your Mini-note optimal operation.
Refer to Chapter 6 on running the SETUP program later.
After the test has completed, your Mini-note will start to search and boot up
the operating system from your hard drive. The Mini-note normally comes
with a Windows operating system pre-installed in your hard drive. Consult the
Windows manual on how to use the program. If not, contact your dealer for
assistance.
2.4 Adjusting the Display Controls
The LCD brightness adjustment is controlled by <Fn> +<
F8 >
and <Fn> +
< F9 >
keys respectively. You need to press these hot-key controls after
powering on your Mini-note to suit your viewing pleasure.
The Brightness hot-key control adjusts the brightness on the LCD. The
brightness hot-key control will not set the LCD completely dark or bright; it
provides sufficient lighting to the LCD to match the external lighting of the
surrounding. The brighter the room, the more you need to increase the
brightness of the LCD.
2.5 Device Drivers Installation
If you already have an operating system installed into your Mini-note, it is best
to install the needed device drivers for using the built-in devices of your Mini-
note. Before installing the drivers, check with your dealer first if they have
already installed all the drivers along with the operating system. If not, follow
the procedures below: