S.CON1M TX/FX Managed Converter
22
Management card configuration
---------------------------------------------------------------------
NETWORK PARAMETERS:
-------------------
IP address on LAN is 192.168.1.99
CONSOLE PARAMETERS:
-------------------
console channel will use a baud rate of 9600
BOARD PARAMETERS:
-----------------
Processor : MPC850, Running at 50Mhz
Board Info : Management Board
Board memory : FLASH : 4Mbytes
SDRAM : 4Mbytes
Board's Ethernet hardware address : 0:A0:D2:2F:80:82
( typical Mac address )
---------------------------------------------------------------------
To change any of this, press <CR> within 3 seconds
Figure 1
– system start-up screen
At this point, you should immediately press any key in order to get to the
device’s configuration procedure. You will get a notification that will enable you
to modify the current settings by typing ‘m’ (or ‘M’).
Now you will be prompted with a series of questions regarding the device’s
configuration. The configuration procedure screen is shown in figure 2. Default
values for each parameter appear in braces. If you do not wish to change a certain
parameter, simply hit ‘Return’.
The different parameters are explained in detail in
figure 2.
When configuration is complete, the startup screen will appear with the new
parameters. If you still want to change the configuration, type
‘m’ to modify
.
Otherwise type ‘
c’ to continue
. Configuration parameters will now be saved
and the system will initialize
(figure 3)
.
