Fibocom L860-GL-16, Hardware Manual, Page: 18 / 60

Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
FIBOCOM L860-GL Series Hardware Guide Page 18 of 60
Pin Definition
The pin definition is as follows:
Pin Pin Name I/O Reset Value Pin Description Type
1 CONFIG_3 O
NC
NC, L860 M.2 module is configured as
the WWAN
– PCIe, USB3.0 interface
type
2 +3.3V PI
-
Power input Power Supply
3 GND
- -
GND Power Supply
4 +3.3V PI
-
Power input Power Supply
5 GND
- -
GND Power Supply
6
FULL_CARD_
POWER_OFF#
I PU
Power enable, module power on input,
internal pull up
3.3/1.8V
7 USB D+ I/O USB data plus, only for debug 0.3---3V
8 W_DISABLE1# I PD WWAN disable, active low 3.3/1.8V
9 USB D- I/O USB data minus, only for debug 0.3---3V
10 LED1# OD T
System status LED, output open drain,
CMOS 3.3V
3.3V
11 GND
- -
GND Power Supply
12 Notch Notch
13 Notch Notch
14 Notch Notch
15 Notch Notch
16 Notch Notch
17 Notch Notch
18 Notch Notch
19 Notch Notch
20 GPIO O PD
GPIO(High-z)
UART_RTS (Reserved)
1.8V
21 CONFIG_0
NC
NC, L860 M.2 module is configured as
the WWAN
– PCIe, USB3.0 interface
type
22 UART_TX O PD
UART_TX, MUX for
ANT_TUNER_CONFIG/GPIO(High-z)
1.8V
Fibocom
Confidential