79-15167-00 REV. A
www.fiberstars.com
Page 9 of 10
CODE ADJUSTMENT
It may be necessary to change the transmission code on the FDS Transmitter to match that of the FDS unit. Check
the FDS product label on the outside to see if the CHANNEL marking is the same as the transmitter. If they do not
match, then follow the instructions below.
TRANSMITTER DIP SWITCHES – Remove all screws from rear of remote. Separate the bottom cover from the
top cover. Take care as to not damage or lose the Rubber seal when separating the bottom cover.
DIP SWITCH ADJUSTMENT – The four DIP switches have an ON and an OFF position. Changing just one DIP
switch will change the code. Change the DIP switches in reference to the Channel Code to match that of the FDS.
Reassemble the bottom cover to the top cover carefully. Ensure that the bottom cover seats onto the top cover.
Screw down the mounting screws until they are snug. Over tightening the screws may damage internal threading
and may cause transmitter bottom not to seal properly. The example below shows DIP switch set to Channel 9.
DIP SWIT CH
1
2
3
4
Channel 1
OFF
OFF
OFF
OFF
Channel 2
ON
OFF
OFF
OFF
Channel 3
OFF
ON
OFF
OFF
Channel 4
ON
ON
OFF
OFF
Channel 5
OFF
OFF
ON
OFF
Channel 6
ON
OFF
ON
OFF
Channel 7
OFF
ON
ON
OFF
Channel 8
ON
ON
ON
OFF
Channel 9
OFF
OFF
OFF
ON
Channel 10
ON
OFF
OFF
ON
Channel 11
OFF
ON
OFF
ON
Channel 12
ON
ON
OFF
ON
Channel 13
OFF
OFF
ON
ON
Channel 14
ON
OFF
ON
ON
Channel 15
OFF
ON
ON
ON
Channel 16
ON
ON
ON
ON
DIP Switch
Rear screws
Rubber seal
CHANNEL
DIP Switch
NOTE: Transmitters are factory set and
shipped on channel 16.