FiberLamp
Software Operation
Page 10 of 19
Copyright 2015
5870081 A1
Programming a Playlist Preset Pushbutton Mode
Follow the steps below to create a unique sequence of lighting scenes and save it to a preset
Playlist Mode of a fixture for stand-alone operation.
1.
Use scroll bars in the
Color
section to customize the color of the light output during the
step. The scroll bars control the intensity of the single color strings of LEDs in the fixture.
2.
Decide how long the step will last by choosing a Play Time in the
Step Duration
section
tab.
3.
If fading throughout the step to the next step is desired, check the Fade box at the bottom
of the
Step Duration
section tab.
4.
If blinking is desired throughout the step, set desired the blinking rate using the Blink Rate
scroll bar.
5.
Once the step is complete, click Add Step at the bottom of the Step Duration section tab
and the step will be shown in detail in the
Step Parameters
section as a step.
6.
Repeat until the series of steps reflect the desired lighting sequence.
7.
Click the Save button on the right hand side of the
Step Parameters
section. After naming
the ‘Profile’, it will be displayed in the
Saved Profiles
section.
8.
To write the ‘Profile’ to the FL5200, Click and Drag the saved ‘Profile’ from the
Saved
Profile
section to the
Selected Profile
section.
9.
In the section
Write Selected Profile to FiberLamp
at the bottom of the LightMix window,
select which ‘Playlist Number’ to assign the newly created ‘Profile’ by clicking on the empty
circle to the left of the ‘Playlist Number’. Playlist 1 will corresponds to Pushbutton mode 7,
Playlist 2 correspond to Pushbutton mode 8, etc.
10.
Click the Write button on the right hand side of the
Write Selected Profile to FiberLamp
section.
11.
Disconnect the fixture from the computer and use the Mode pushbutton to select the mode
to which the new Playlist has been written.
