This function is important to energy saving, if this function hasn’t been set when
the battery is in use, then the welding times will be reduced.
(1) Insert the battery and power on.
(2) Select [energy saving] in the [system setting] option.
(3) Change the values of [displayer auto off] and [fusion splicer auto off].
②
Select the position that you need (front/back), and then preserve.
After you select [system information] will display the following messages.
Note: You can also fast switch the position of displayer, press the left and right key
to do fast operating on initial interface.
During some certain time period,if the fusion splicer didn’t work,then the
displayer will auto off.When the battery is in use,you should set a specific
turn-off time.
When the displayer is turning off,the indication light which near the power
supply key will flash,the displayer will auto on if you press any key.
Parameters
Description
Displayer
auto off
8.2.3 System information
8.2.2 Energy saving position
32
Machine serial number
Parameter
Software edition
CPLD
FPGA
Discharging counts
Total counts
Last maintenance
Next maintenance
Display the serial number of the fusion splicer.
Description
Display the software version number.
Display CPLD version number.
Display FPGA version number.
Display the discharging counts after replace the electrode, execute [replace
electrode]or[discharging counts deletion] to initialize the parameter to zero.
Display the date of last maintenance.
Display the total discharging counts.
Display the next maintenance time that scheduled.
