23
For the setting of splice mode
Chapter 5 Splice option
③
Press left and right key to modify. After modification, press for confirmation.
Parameter
Description
Auto-Start
If auto-begin is set to “ON”, and then it will auto-splicing after close the windproof cover.
Pause One
Cutting angle Set it to “OFF” will prevent the fusion splicer continue to discharge when display “cutting angle error”.
Fiber Core angle Set it to “OFF” will prevent the fusion splicer continue to discharge when display “fiber core angle error”.
Interval set Set the fiber display mode during splice course.
：
Display X scene interface image separately.
Pause One
Pause Two
: Display Y scene interface image separately.
：
Simultaneously display X and Y scene interface image.
Discharging
Estimate
If “pause One” is set to “ON”, when fiber move to the interval position, splice
will stop and will show cutting angle.
Bad condition
on Cutting end Set it to “OFF” will prevent the fusion splicer continue to discharge when display “cutting angle error”.
Loss
Set it to “OFF” will prevent fusion splicer continue to finish splicing when display
the warning signals such as “excessive loss”, “excessive fiber core intersection
angle”, “bubble”, “fiber too thick” or “ fiber too thin”.
Thick
Thin
Pause Two
If “pause Two” is set to “ON”, operating will be pause after fiber finish “core to
core” alignment.
Neglect splice fault
Fiber images on the screen
①
Enter into the splice option menu.
②
Press up and down button to select the option that need to modify.
