8
InstallatIon
4.2:
Preparing for installation
Prepare wires by removing 11.5-13mm of insulation from their ends.
You can use groove on the side of the unit to measure the length.
When installing with FIBARO or GIRA cover plates:
1. Pull out the switch button.
2. Take off the cover plate.
When installing with Legrand or Schneider cover plates:
1. Pull out the original switch button.
2. Take off the original cover plate.
3. Dismount the original mounting frame.
4. Snap the new mounting frame*.
* Additional mounting frames are sold separately.
4.3:
Electrical connection
1. Switch off the mains voltage (disable the fuse).
2. Connect with one of the diagrams below:
N
L
Diagram 1: Example con-
nection for double switch
configuration
N
L
Diagram 2: Example con-
nection for single switch
configuration
3. Verify correctness of connection.
4. Tighten the terminal screws using PH1 screwdriver.
