6
OPERATInG ThE DEVICE
#4: Operating the device
Waking up the device:
The KeyFob needs to be woken up to receive information about the
new configuration from the Z-Wave controller, like parameters and
associations. Use 1st menu position (white) or click
and
simulta-
neously to wake up the device.
Menu
allows to perform Z-Wave network actions. In order to use the
menu:
1. Click and simultaneously.
2. Click or
until LED indicates desired menu position with colour:
• White
- wake up the device
• Green
- learning mode (adding/removing)
• Cyan
- check battery level
• Yellow
- reset the device*
3. Click to confirm selection, Click
to exit the menu.
4. LED will pulse twice with same colour as selected menu position
to confirm completing action.
Resetting the device to factory defaults:
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user configuration will be deleted. There are two ways of resetting the
device:
Resetting the device
using the menu
:
1. Click and simultaneously.
2. Click or
until LED glows yellow.
3. Click .
Emergency resetting the device
on start-up
:
1. Remove the battery.
2. hold and , while inserting the battery.
Successful resetting will be confirmed by smoothly brightening and
dimming of the yellow LED colour.
NOTE
* Resetting the de-
vice from the menu
is not available in
Lock Mode.
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. Use
the reset procedure
only if the primary
controller is missing
or inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in "Adding/
removing the device"
on page 5.
i
i