3
.
Make your selection highlighting the button
.
Depending on the vehicles options, the following feature settings are available:
•
Display
•
Audio
•
Clock & Date
•
Phone/Bluetooth
•
Safety/Assistance
•
SiriusXM Setup
•
Lights
•
Restore Settings
•
Doors & Locks
•
Clear Personal Data
UNIVERSAL GARAGE DOOR OPENER (HomeLink)
HomeLink
replaces up to three hand-held transmitters that operate devices such as
garage door openers, motorized gates, lighting or home security systems
.
The HomeLink
unit is powered by your vehicles 12 Volt battery
.
HomeLink buttons that are located in the sun-visor designate the three different
HomeLink channels that can be programmed
.
A HomeLink indicator light
is located above the center button
.
Before You Begin Programming
HomeLink
Ensure that your vehicle is parked outside
of the garage before you begin program-
ming
.
For efficient programming and accurate
transmission of the radio-frequency signal, it
is recommended that a new battery be
placed in the hand-held transmitter of the
device that is being programmed to the
HomeLink system
.
To erase the channels, place the ignition switch into the ON/RUN position, then push and
hold the two outside HomeLink buttons (I and III) for up to 20 seconds or until the red
indicator flashes
.
NOTE:
Erasing all channels should only be performed when programming HomeLink for the first
time
.
Do not erase channels when programming additional buttons
.
If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on
the Internet at HomeLink
com for information or assistance
.
HomeLink Buttons
ELECTRONICS
94
