ESC Full Off
This mode is intended for off-highway or off-road use only and should not be used on
public roadways
.
In this mode, all TCS and ESC stability features are turned OFF, except
for the limited slip feature described in the TCS section
.
To enter the “Full Off” mode,
push and hold the ESC OFF switch for five seconds
.
After five seconds, the ESC OFF
Indicator Light will illuminate, and the “ESC OFF” message will display in the EVIC
.
To turn
ESC ON again, momentarily push the ESC OFF switch
.
– Park/Headlight ON Indicator
This indicator will illuminate when the park lights or headlights are turned on
.
- Power Steering System Warning
This light is used to manage the electrical warning of the EPS (Electric Power Steering
System)
.
When the ignition is turned to the MAR position, the warning light will illuminate
momentarily
.
If the warning light stays on, cycle the ignition to the STOP position and
back to MAR
.
If the warning light stays on, contact your authorized dealer
.
If the warning light switches on while driving, you may not have steering assistance
.
Al-
though it will still be possible to steer the car, the effort needed to operate the steering
wheel could be increased: contact an authorized dealer as soon as possible
.
– Defroster Indicator
Indicates that defroster is on
.
Change Engine Oil
•
Your vehicle is equipped with an engine oil change indicator system
.
The “Change En-
gine Oil” message will flash in the EVIC display for approximately 10 seconds after a
single chime has sounded to indicate the next scheduled oil change interval
.
The engine
oil change indicator system is duty cycle based, which means the engine oil change in-
terval may fluctuate, dependent upon your personal driving style
.
•
Unless reset, this message will continue to display each time you turn the ignition
switch to the MAR position
.
To turn off the message temporarily, push and release the
MENU
button
.
To reset the oil change indicator system (after performing the sched-
uled maintenance), refer to the following procedure:
1
.
Turn the ignition switch to the MAR position (Do not start the engine)
.
2
.
Fully depress the accelerator pedal slowly, three times within 10 seconds
.
3
.
Turn the ignition switch to the STOP position
.
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset
.
If necessary, repeat this procedure
.
WHAT TO DO IN EMERGENCIES
107
