Assembly Instructions
1.
Remove protective plastic covering from all surfaces.
2.
Remove grid and wash in hot soapy water, rinse and dry.
3.
Clean all surfaces with a clean, hot, damp cloth.
4.
Replace grid on drive studs.
Installation
Position the
Hot Dog Grill
near a suitable electrical supply; ensure that the electrical cable
cannot cause a tripping hazard etc.
Operating Instructions
Turn RED switch 'ON', the digital control will display a temperature and then the grid will
travel up and down, heating will commence.
Allow 20 minutes for grill plate to pre-heat.
Temperature control is factory pre-set at 90°C.
Using tongs, place hot dogs/frankfurters between roller bars. Product will be ready to
serve in 10-15 minutes, depending on size and thickness. Recommended internal
temperature of product should be 68°C - 70°C.
NEVER LEAVE TONGS ON OR BELOW A MOVING GRID.
Note:
All HOT DOG GRILLS operate on a "heat n' hold" principle. The pre-set grill plate
temperature will heat the hot dogs in a matter of minutes and hold them for several hours
with little or no deterioration in appearance or taste. If there are any early signs of
deterioration, the grill plate temperature should be lowered, see "GRILL PLATE
TEMPERATURE" instructions.
Grill plate temperature
The grill plate temperature has been factory pre-set at 100°C. This operating temperature
can be adjusted between 90°C and 110°C. To change the temperatures proceed as follows:
To set an operating temperature between the factory set parameters. Push and
hold
“SET” button
and with the
-
and the
-
button set the required
temperature.
Summary of Contents for VIHD2
Page 1: ...Hot Dog Grill 2 VIHD2 Hot Dog Grill 4 VIHD4...
Page 12: ......
