19
TS 75
X
Push switch lock
[4-1]
up and push sawing unit
down until it locks into place,
X
Loosen screw
[4-6]
with Allen key
[4-3]
,
X
Set spacer wedge as shown in diagram
[4]
,
X
Tighten screw
[4-6]
,
X
Put lever
[4-2]
back.
6.6
Dust extraction
WARNING
Dust hazard
X
Dust can be hazardous to health. Always work
with a dust extractor.
X
Always read applicable national regulations
before extracting hazardous dust.
A Festool mobile dust extractor with an extractor
hose diameter of 27 mm or 36 mm (36 mm
recommended due to the reduced risk of clogging)
can be connected to the extractor connector
[6-1]
.
6.7
Mounting the splinterguard
The splinterguard (accessories) significantly
improves the quality of the cutting edge of the
sawn workpiece on the upper side for 0° cuts.
X
Attach splinterguard [5-1] onto the protective
cover,
X
Place machine onto the workpiece or the guide
rail,
X
Press splinterguard down until it sits on the
workpiece and tighten it with the rotary knob
[5-2]
.
X
Saw splinterguard in (machine to maximum
cutting depth and speed range 6).
7
Working with the machine
Please observe all mentioned safety
informations and the following rules
when working:
– Only guide the machine against the workpiece
when it is switched on.
– Check the installation fixture prior to use and
do not use the machine if the fixture does not
function correctly.
– Always secure the workpiece in such a manner
that it cannot move while being processed.
– Always hold the machine with two hands at the
handles
[1-1, 1-6]
when performing work. This
reduces the risk of injury and is a prerequisite
for precise work.
– Always push the machine forwards
[1-2]
, never
draw the machine towards yourself.
– Adapt the fast-feed speed to prevent the cutters
on the saw blade from overheating and prevent
plastic materials from melting during cutting.
– Make sure that all rotary knobs are tightened
before starting work.
– Do not use the machine when the electronics
are faulty because the machine may operate
at excessive speeds. An absence of the smooth
start-up function or speed control indicates that
the electronics are faulty.
For work that generates dust, wear a
dustmask.
7.1
Sawing along the scribe mark
The cutting indicator
[6-3]
displays the cutting line
for 0° and 45° cuts (without guide rail).
7.2
Cutting sections
Place the machine with the front part of the saw
table on the workpiece, switch the machine on,
press it down to the preset cutting depth and push
it forward in the cutting direction.
7.3
Sawing cut outs (plunge cuts)
In order to avoid kickbacks, the
following instructions must be observed
without fail when plunge cutting:
– The machine must always be placed with the
rear edge of the saw table against a fixed stop.
When working with the guide rail, the tool must
be placed at the kickback stop
[7-1]
, which is
firmly clamped on the guard rail (see Fig
[7]
;
when not in use, the kickback stop can be kept
in safekeeping at the guide plate
[7-2]
of the
machine).
– The machine must always be held securely with
both hands and only plunged slowly.
Procedure
X
Place the machine onto the workpiece and
position it against a stop (kickback stop), switch
the machine on, slowly press it down onto the
set cutting depth and push it forward in the
cutting direction.
The markings
[6-2]
indicate the absolute front
and the absolute rear cutting points of the saw
blade (dia. 210 mm) at maximum cutting depth
and using the guide rail.
