Festool HL 850 E, Original Operating Manual/Spare Parts List

Page: 11 / 62

11
Technical data HL 850 EB/HL 850 E
Power 850 W
Speed (no load)
HL 850 EB 11000 rpm
HL 850 E 10000 rpm
Plane width 82 mm
Chip thickness 0 - 3.5 mm
Max. rebate depth unlimited
Weight (excluding cable) 3.9 kg
Degree of protection / II
The speci fi ed illustrations can be found
at the beginning of the operating instruc-
tions.
1 Intended use
The tool together with the available Fes-
tool accessories is designed for processing
wood, soft plastics and similar materials.
The user is liable for damage and
injury resulting from incorrect us-
age!
2 Safety instructions
2.1 General Safety Rules
Before using the machine, read all
safety instructions and these op-
erating instructions carefully and
thoroughly.
Save all enclosed documents and pass the
machine with all these documents only.
2.2 Tool-speci fi c safety rules
Wait for the cutter to stop before setting
the tool down. An exposed cutter may en-
gage the surface leading to possible loss of
control and serious injury.
Wear suitable personal pro-
tection equipment: Ear pro-
tection to reduce the risk of
damaging your hearing; Pro-
tective goggles; Face mask
to reduce the risk of inhaling
harmful dust; Protective
gloves when handling tools
and coarse materials
2.3 Noise and vibration infor-
mation
The typical values determined in accord-
ance with EN 60745 are:
Sound-pressure level 80 dB(A)
Sound-power level 91 dB(A)
Measuring uncertainty allowance K = 4 dB
Wear ear protection!
Overall vibration levels (vector sum for
three directions) measured in accordance
with EN 60745:
Vibration emission level (3 directions):
a
h
< 2.5 m/s²
Uncertainty K = 1,5 m/s²
3 Power supply and start-up
The mains voltage must correspond
to the speci fi cation on the rating
plate.
To switch on, fi rst press the switch lock
(1.1) and then the switch (1.2) (press =
ON, release = OFF).
4 Electronics
The tool has full-wave electronics
with the following features:
Smooth start-up
The smooth start-up ensures the router
starts up jolt-free.
Constant speed
The pre-selected speed remains constant
whether the machine is in operation or in
neutral position.
Brake (HL 850 EB)
After switching-off, the tool is electronically
brought to a standstill in 1.5 – 2 seconds.
5 Machine settings
Always remove the power supply
plug from the socket before carrying
out any work on the machine.
5.1 Chip thickness adjustment
- Open the lock (3.1) by pressing to the
rear.
- Set the chip thickness by turning the han-
dle (3.2). The scale (3.3) indicates the set
chip thickness.
- Close the lock (3.1) by pressing to the
front to lock the set chip thickness.
The max. planing depth is 3.5 mm. So as
no to overload the machine, we recommend
that a maximum planing depth of 2.5 mm
be set with a plane width > 40 mm.