9
2 Symbols
Warning of general danger
Read the operating instructions/notes!
Do not throw in the household waste!
Advice or tip
3 Intended
use
The drilling stands
GD 320 and GD 460
are in-
tended for precise drilling at the precise angle of
90°. By means of the guiding disk, it is possible to
guide the spiral drills from dia. 8 to 26 mm, even-
tually, from dia. 6 to 27 mm, precisely and safely.
Without a guiding disk, the maximum drilling
depth is 45 mm. Two parallel stops server for a
simple placement, or eventually, guiding on the
material. The clamping elements for clamping
the stand can be ordered as accessories. The
stand can be employed with all electric drilling
machines with the clamping neck of the dia. 57 or
43 mm that do not exceed the maximum torque
of 75 Nm.
The drilling stand
GD 460 A
can be employed for
drilling at an arbitrary angle in the range from
90° to 45°.
Original instruction manual
1 Technical Data
Carpenter Stand
GD 320
GD 460
GD 460 A
Maximum drill length
320 mm
460 mm
460 mm
Maximum drilling depth
240 mm
380 mm
310 mm
Guiding disk for drills
dia. 8, 10, 12 ... 26 mm
Maximum drilling dia. without guiding disk
45 mm
Tilting at an angle
-
-
up to 45° steplessly
Clamping for drilling machines with clamping neck of the dia. 57/43 mm
Weight
2,8 kg
3,2 kg
3,7 kg
Overall height
532 mm
672 mm
672 mm
Base board
185 x 172 mm
185 x 172 mm
207 x 172 mm
Parallel stop - adjustable
8 - 190 mm
- in vertical direction
-
-
25-185 mm
Accessories, not included in the scope of the delivery
Order No
Guiding disk for spiral drills of the dia. 6,7,9,11 ... 27 mm
621947
Clamps (4 pcs) for clamping the stand for material up
621949
to 105 mm (up to 127 mm for GD 460 A)
Brackets (2 pcs) for fastening the clamping elements
622471
stand up to the material width of 300 mm
4 Safety
Instructions
WARNING! Read all safety warnings and
all instructions.
Failure to follow the warn-
ings and instructions may result in electric shock,
fi re and/or serious injury.
Save all warnings and instructions for future
reference.
-
The combination of the hand drilling machine
with the stand creates a piece of equipment for
which the safety and operating instructions for
the drilling machine apply. Therefore, read also
the safety and operating instructions for the
drilling machine.
-
During work, it is necessary to hold the equip-
ment with both hands, gripping the respective
handles.
-
Before starting work, it is necessary to check
and make sure that the rotating parts of the
machine may not collide with the stable parts
of the drilling stand or with the material during
the drilling operation.
-
Before starting work, it is necessary to check
and make sure that all the elements intended
for securing the position, the clamping etc., are
well tightened and secured.
-
During the operation, the loose chips, splinters
and similar pieces must not be removed from
the vicinity of the tool by hand.
