Contents
1 Symbols.....................................................17
2 Safety warnings.........................................17
3 Intended use..............................................21
4 Technical data........................................... 21
5 Parts of the machine.................................21
6 Commissioning..........................................22
7 Battery pack.............................................. 22
8 Settings......................................................22
9 Working with the electric power tool........24
10 Acoustic warning signal............................24
11 Accessories............................................... 25
12 Service and maintenance..........................25
13 Environment..............................................25
14 General information..................................25
1
Symbols
Warning of general danger
Warning of electric shock
Read the operating manual and safety
instructions.
Wear ear protection.
Wear protective gloves.
Wear a dust mask.
Wear protective goggles.
Wear sturdy shoes.
Do not dispose of it with domestic
waste.
Tip or advice
Handling instruction
Inserting the battery pack
Removing the battery pack
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
2
Safety warnings
2.1
General safety instructions
WARNING! Read all safety warnings and
all instructions.
Failure to follow the
warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Follow the operating manual for the charger
and the battery pack.
2.2
Machine-specific safety notices
General safety warnings for sanding, wire
brushing and abrasive cutting
–
This power tool is designed to be used as a
sander, wire brush and abrasive cutting
machine. Read all safety warnings, infor
mation, illustrations and technical data
enclosed with the tool.
If the following in
structions are not observed, this may lead
to electric shock, fire and/or serious inju
ries.
–
This power tool is not suitable for sanding
using sandpaper or polishing.
Applications
for which the power tool is not intended can
pose a serious risk and cause injuries.
–
Do not use accessories which are not spe
cifically designed and recommended by
the tool manufacturer.
Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
–
The rated speed of the accessory must be
at least equal to the maximum speed
marked on the power tool.
Accessories
running faster than their rated speed can
break and fly apart.
–
The outside diameter and the thickness of
your accessory must be within the capaci
ty rating of your power tool.
Incorrectly
sized accessories cannot be adequately
guarded or controlled.
–
Threaded mounting of accessories must
match the grinder spindle thread. For ac
cessories mounted by flanges, the arbour
hole of the accessory must fit the locating
diameter of the flange.
Accessories that do
not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
–
Do not use a damaged accessory. Before
each use inspect the accessory such as
English
17
