Festool 575622, Instructions Manual

Page: 33 / 34

33
English
-
Use an extractor to remove dust deposits.
- Keep the guide rods clean and grease them
regularly.
- Keep the toothed gears behind the rotary han-
dle [2-3] clean.
- Replace worn or damaged table inserts
[1-7]
.
- If wood chips block the extraction channel on
the bottom guard, unscrew the rotary knob
[5-8]
and move the flap
[5-6]
approx. 8 mm
to open up a gap so that the blockage can be
removed.
- If the blockage is serious or the saw seizes
when the initial cut is made, use the hex key
to unscrew the fasteners
[5-7]
so that the flap
[5-6] can be opened completely. Close the flap
again prior to use.
- After completing work, wind the power cable
[11-1] around the accessory holder [11-4] .
- A damper allows the saw unit to retract evenly
along the entire cutting length. If this is not the
case, the damper can be adjusted using the hole
[4-5] . The dampening effect can be increased
by turning the adjustment screw clockwise.
Filter cleaning
You should clean the air intake filter [4-2] if the tem-
perature monitor (see section 7.1) triggers shut-
down cycles more frequently without the machine
being overloaded excessively.
f
Unscrew the rotary knob [4-1] .
f
Remove the filter insert.
f
Knock out the dust or use an extractor on the
filter surface area.
f
Put the filter back in.
L
Replace a damaged filter with a new filter
cartridge.
11 Accessories, tools
Festool provides comprehensive accessories
which allow you to use your machine effectively
and for diverse applications, e.g.: Extension ta-
bles (width and length), sliding table, trimming
attachment, dust extraction set.
In order to be able to saw different materials
quickly and cleanly, Festool offers saw blades
that are specially designed for your machine.
Refer to the Festool catalogue for the order
numbers of accessories and tools.
12 Disposal
Do not throw the power tool out in your house-
hold waste. Dispose of machines, accessories
and packaging at an environmentally responsi-
ble recycling centre. Observe the valid national
regulations.
EU only : In accordance with European Directive
2002/96/EC on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh:
www.festool.com/reach.