Festo Pick&Place Station, Manual

Page: 97 / 104

6. Commissioning
© Festo Didactic 678864
97
1. Fill the slide with a maximum of 6 workpiece inserts. The opening of the
workpieces must point upwards.
2. Check the voltage supply and compressed air supply.
3. Remove workpieces at the transfer points of modules or stations prior to manual
reset.
4. Carry out the reset sequence. The reset sequence is prompted by an illuminated
RESET pushbutton and executed when the pushbutton has been pressed.
5. Put a workpiece (housing) at the start of the conveyor belt.
6. Start the sequence of the Pick&Place station. The start is prompted by the
illuminated START button and carried out when the pushbutton has been
actuated.
Notes
•
The sequence can be interrupted at any time by pressing the EMERGENCY-STOP
pushbutton or by pressing the STOP pushbutton.
•
With the key-operated switch AUTO/MAN, you can select either the continuous
cycle (AUTO) or individual cycle (MAN).
•
The following applies in the case of a combination of several stations:
The individual stations are reset against the material flow.
6.10
Starting the sequence