Radar Training System, LabVolt Series
25
© Festo Didactic
Radar Jamming Pod Trainer Support
581916 (9595-10)
This support is a mast designed to support the Radar Jamming Pod Trainer
when it is used to perform electronic jamming against the Radar. The large
base of the mast provides stable support of the Radar Jamming Pod Trainer.
Soft pads attached under the base allow the mast to glide softly over the
surface of the Target Positioning System.
Power Supply / Antenna Motor Driver
8084743 (9601-20)
The Power Supply / Antenna Motor Driver is the physical base
for the Basic Radar Training System. Several modules of the
system are designed to be stacked on top of it side-by-side. The
power supply distributes three unregulated dc voltages to the
stacked modules through self-aligning connectors. These voltages are regulated within each module to provide
the required voltages. Three regulated dc voltage outputs are also available through miniature banana jacks on
the front panel of the power supply.
The antenna motor driver supplies power to the Model 9603 Rotating-Antenna Pedestal. It is a Pulse-Width-
Modulated (PWM) motor driver that uses a four-quadrant chopper requiring a command signal from the antenna
controller or radar target tracking system. It is equipped with front-panel test points for training purposes.
Specifications
Parameter
Value
Power Requirement
Current
Service Installation
Standard single-phase ac outlet
Power Supply
Unregulated DC Outputs
-25 V typ. -3 A max.; +11 V typ. - 5 A max. (two separate outputs); +25 V typ. - 3 A max.
Regulated DC Outputs
-15 V at 0.5 A; +5 V at 1 A; + 15 V at 0.5 A
AC Line Protection
Regulated DC Output Protection
Unregulated DC Output Protection
Antenna Motor Driver
Input Voltage Range
-10 to +10 V
PWM Output Voltage Range
-24 V to +24 V max.
Physical Characteristics
Dimensions (H x W x D)
104 x 687 x 305 mm (4.1 x 27 x 12 in)
