10 / 20
Festo 7Tension01_TBb_en
6.2.2
Attaching the stop bolts
Note
The test equipment is placed on the left or right of the slide/piston on the
toothed belt axisdepending on the size and design of the toothed belt axis
(see table in section
6.2.3 “Attaching the test equipment”
). Observe the
prescribed test position when screwing the respective stop bolt into the test
equipment.
The designations in the table refer to the side where the slide/piston is at-
tached to the test equipment or the stop bolt. S.L. means that the slide/piston
is attached on the left of the test equipment, S.R. means that the slide/piston
is attached on the right of the test equipment. The designations are engraved
into the test equipment.
•
Unscrew the relevant stop bolt from the top of the test equipment and
screw it into the specified thread on the front side of the test equipment
(see table).
Type
Stop bolt diameter
Item
DGE-25-ZR(-KF)
13 mm
E
DGE-40-ZR(-KF)
No stop bolt
-
DGE-63-ZR(-KF)
No stop bolt
-
DGE-25-ZR-RF
13 mm
E
DGE-40-ZR-RF
13 mm
E
DGE-63-ZR-RF
13 mm
F
EGC-50-TB-KF
8 mm
A
EGC-70-TB-KF
11 mm
B
EGC-80-TB-KF
13 mm
C
EGC-120-TB-KF
13 mm
S.L.: C, S.R.: F
EGC-185-TB-KF
13 mm
E
ELGA-TB-G-70
11 mm
E
ELGA-TB-G-80
11 mm
E
ELGA-TB-G-120
11 mm
E
