3. Installation of the central control unit CMXR-C2
44
Festo GDCP-CMXR-C2-HW-EN 1002NH
RJ45 socket [X7]
Pin
Signal
Explanation
1
2
3
4
5
6
7
8
Metal covering
TD+
TD-
RD+
n.c.
n.c.
RD-
n.c.
n.c.
Shield
Transmitted data+
Transmitted data
Received data+
Not connected
Not connected
Received data
Not connected
Not connected
Screening
Table 3.11 Pin allocation for the Ethernet interface [X7]
Instructions on wiring can be found in section 3.3.
3.4.10
Using Compact Flash memory cards
To operate the multi-axis control system CMXR-C2, a Compact Flash memory card with the
corresponding firmware and application (where necessary) must be inserted in the slot.
Dependent on the application used, the memory card is used for storing machine data
(e.g. tool data and formulas). The memory card cannot be used as a removable medium
because system programs are also stored on it. Only the Festo memory card CAMC-P3-C-
M256 can be used.
Precautionary measures to be taken when handling memory cards
Caution
Memory cards can be damaged if handled incorrectly!
Do
not
remove or insert the memory card during operation.
Do
not
switch off the device whilst it is writing onto the memory
card.
Do
not
insert the memory card into the slot with too much force.
Do
not
drop or bend the memory card.
Keep the memory card away from moisture, heat and direct
sunlight.
Keep the memory card away from electrostatic sources or
magnetic fields.
The memory card is designed in such a way that it can only be inserted into the device in
one direction. The card should simply slide into the slot. The status LED next to the
ejection button lights up if the device has read or write access to the card.
Summary of Contents for CMXR-C2
Page 2: ......
Page 5: ...Festo GDCP CMXR C2 HW EN 1002NH 5...
Page 56: ...6 Maintenance and care 56 Festo GDCP CMXR C2 HW EN 1002NH...